This performance intercooler kit is developed by do88 to replace the original / OEM intercooler system, and gives true bolt-on performance without the need of extensive engine modification. Comes with hoses/pipes/and clamps to replace all the underperforming stock components in your P2 Volvo. There is no better intercooler kit available on the market.

Significant advantages with do88 performance intercooler (OEM intercooler):

• Core volume: 13068cm3 (8659cm3), do88 is 51% larger!
• Air flow at 0,15bar/2,18psi pressure drop: 319CFM (272CFM), do88 17% higher! See diagram below!
• Post intercooler air temperature at same conditions: 30°C (54°C), do88 24°C lower! See diagram below!
• CLICK FOR INSTALLATION INSTRUCTIONS
• 2003- and up.

This do88 performance intercooler features an all aluminum construction with CAD designed, flow optimized cast end tanks and core design to achieve the best possible cooling efficiency combined with lowest possible pressure drop!

The OEM intercooler have plastic tanks that don’t keep up with higher boost levels very well so the do88 performance intercooler will also add reliability!

A common misunderstanding is that an intercooler installed in this position cannot provide good performance and a front mounted intercooler / FMIC would be much better. Actually the do88 performance intercooler are far better than most FMIC installations where only a core with small front surface are possible to install and often also installed partially behind the bumper beam which will reduce cooling capacity even further and often cooling below the OEM intercooler are achieved.

do88 performance intercooler comes with all hardware necessary for installation. This intercooler includes additional hardware to fit all Volvo S60 / V70 / XC70 / S80 turbo models with or without sensor on the intercooler outlet.

This do88 performance intercooler installs in original position with original fastenings.

NOTE! When installing this intercooler on a S60 R / V70 R the small auxiliary intercooler needs to be removed as it no longer will be used. On R-models the grille is a part of this auxiliary intercooler. This means when you remove this intercooler you will have to install an new mesh if you which to have a grille / mesh in this opening. You don't have to install a mesh, if you don't do this the bumper intake hole will just be open into the AC-condenser.

This kit is for the Volvo driver with significant horsepower goals. This pressure pipe kit has considerably better airflow than the stock pipe. This has been verified in several tests, both in car and in do88's SuperFlow SF-1020 flow bench.

Significant advantages with do88 pressure pipes:

• Significantly improved Air flow!
• Designed to handle high pressure and temperatures!
• Manufactured in 2,5" / 2,75” mandrel bent seamless aluminum pipe.
• Custom made high quality silicone hoses with 4 layers of polyester/aramid reinforcement.
• CLICK FOR INSTALLATION INSTRUCTIONS

These hoses can handle very high temperature and pressure!

Always remember that the OEM intercooler pipes and hoses were designed for the power level the car was built for, and a power increase (or even very hard use of the car in stock form) may result in lack luster performance. So only after engine software tune do88 pressure pipes will give a power increase over the OEM pipes!

Included parts:

• Upper intercooler pipe
• Lower intercooler pipe
• Hoses turbo to pipe
• Hose pipe to intercooler
• Hose intercooler to pipe
• Hose pipe to throttle body
• Hose clamps 4pcs 60-80mm
• Installation parts for sensors, only for cars with sensors on lower pipe.