The first one after install worked great, held up great, but then the dreaded oil pan gasket and rear main seal leaks migrated into the bell housing and caused the clutch to start slipping. Yes I replaced the rear main seal and oil pan gasket with this new clutch. The alignment tool in this kit does not work for my car, I needed the BMW version tool (which they sell here) replace your hardware while your at it, it’s cheap insurance. The kit would benefit from a slightly larger size packet of grease for the splines on trans shaft. 07 335i E93

Came with all of the requirements but I bought a separate clutch Alignment just in case.

Looks exactly the same as my 335i clutch cant see any difference so ill just have to trust that this one is stronger. The alignment tool that this clutch comes with is wrong so you have to by the oem alignment tool. And dont forget to order a new pivot pin i used a plastic oem part since the last one held up well

Great clutch for the price, been holding 400whp for the past year.

Works great with my N54 single turbo. You need to buy flywheel bolts and pressure plate bolts.

Purchased this Luk Clutch kit for my 07 e92 335i. I went with M Factory SMFW. This was my first time doing a clutch on a car and I must say that everything fit perfect! Clutch arrived fast, came with everything. Didn't need to use alignment tool since it was a self-adjusting clutch but 3000 miles later and clutch feels great! Pedal pressure is a tard bit heavier than my old clutch and it grabs a little harder but still very easy to drive. I highly recommend!

Used as a slight clutch upgrade for my N55 powered E90. Everything worked well except for the clutch alignment tool which was wayyy too long. I had to cut off about 1/2 inch from the back, and then it worked as well.

Clutch feels amazig and Is handling roughly 500whp on my 335i

Clutch has held great for 4000 miles including two track days and abuse from clutch drops to finish off a sets of tires. What more can you ask for?

I've seen it asked a few times a couple of Facebook groups, and it doesn't mention anything on it here. This does come with a clutch alignment tool, no need to buy one separately. Overall, great kit, with the BMW Dual Mass Flywheel - Luk 21207590942 it installs with a breeze, just remember that the pressure plate bolts do not come with this kit and you will need to purchase them (BMW Pressure Plate Screw - Genuine BMW 21207548052) since they are single use bolts.