Exactly what my CDI needed. Easy DYI install if you get creative with your ratchet extensions.

This thermostat came with the temp sensor, works great EXCEPT during installation there are 2 mounting holes that are not tapped, the screws are NOT thread cutting screws but normal M6 screws. So get yourself a 6mm x 1.00 tap and tap the two holes before installing the thermostat. Both holes are for bracket mountings, one is for the fuel lines and the other is for a stiffener. Wet the tap with WD-40, and don't back the tap out until its bottomed out in the hole, and you will come out with perfect threads. Flush the holes with WD-40 to remove chips, and flush the tap before the next hole is tapped. Torque to 9Nm. You should use an electronic torque wrench for perfect results when mounting the thermostat.