AEM Infinity-8 (Can Enabled) - 30-7109

Infinity EMS

The new AEM Infinity EMS delivers high end engine control at a fraction of the cost. Combined with AEM's industry leasing after purchase support system, including free technical support, the Infinity is the ultimate engine control solution for professional race teams and weekend track cars. It has been built around the lastest generation 32 bit, 200MHz automotive processor making the Infinity EMS capable of 400 million instructions per second.

For more information please check out AEM's website here.

Map Switching
AEM incorporated the Infinity’s map switching capability into the factory steering wheel buttons, eliminating the need to wire in and mount an ancillary position switch. Using InfinityTuner software, users can now select from 8 modes for boost control maps, fuel maps, timing maps, Lambda target maps and more and select maps on the fly using the factory cruise UP (+) and DOWN (-) buttons.

To ensure that drivers know which mode they are in when not connected to the Infinity ECU, when the vehicle is keyed ON the tachometer moves to a specific RPM point to indicate which map the Infinity is using (for example 3k RPM indicates Mode 3, 4k RPM indicates mode 4, etc.). When the driver changes maps while driving, the tachometer will temporarily change from revs to the RPM point that indicates the switched mode for one second and then resumes normal tachometer operation. Actual engine RPM will not be affected during this one second period.

Three-Step Rev Limiter
Users can configure the CRUISE ON/OFF (1/0) as a Temporary three step limiter switch through the InfinityTuner software (vehicle speed or time after launch dependent), and can set rev limits at specific rpm by points or set a flat limiter and use it as an RPM hold for launches.

Definable Rev Limit on Tachometer
The E46 M3’s tachometer incorporates an LED ring around the outer perimeter to suggest rev limits, and the Infinity ECU uses these LEDs to indicate user defined active rev limits. For instance, if the Coolant Protect feature in InfinityTuner is set with a rev limit to 5k RPM when the engine is cold, the rev limit is indicated via the lights around the perimeter of the tachometer until defined coolant temps for normal operation are achieved. Whatever rev limits a user configures will always be displayed, with the lowest defined rev limit value taking precedence in the LEDs surrounding the tachometer. This feature applies to any protect features, the three step limiter, etc.

Traction Control
The E46 M3 comes with wheel speed/ABS sensors from the factory, and the Infinity is able to use them for traction control via fuel cut, spark cut or retracting DBW throttle response. This eliminates the need to install additional sensors for traction control.

The CRUISE SET/HOLD (speedometer icon) can be configured as a traction control enable or disable button through the InfinityTuner software. Users can define a specific slip target for traction control in the software and turn it on or off using this button, or set two slip targets and use it for a mild and aggressive traction control strategy.

User Definable DBW Throttle Response
Users can define throttle curves in the InfinityTuner DBW software and take full control of throttle response using the Sport button near the shifter. This allows users to change throttle response rate on the fly and is ideal for setting rain mode throttle curves.

Fits These Cars:

2001 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
2002 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
2003 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
2004 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
2005 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
2006 BMW M3 Engine Control Module
Engine base: 3.2L L6, Sub model: Base, Transmission control type: Standard
Requires AEM part number 30-3510
Product match fitment

AEM Infinity-8 (Can Enabled) - 30-7109

Brand:
Aem electronics logoAEM Electronics
SKU #:
AEM-307109
Part:
Engine Control Module
FCP ID:
207433
$3,235.99 MSRP: $3,883.99
Make sure this part fits.
Select your vehicle
Qty:
Available
Ships within 1 business day
  • Guaranteed to Fit, Guaranteed for Life We guarantee the fit and quality of our parts for life. If it doesn’t meet your expectations send it back for a replacement or refund. Learn more
  • Fitment Verified This product application guide has been tested to ensure it will accurately fit the cars outlined in our fitment guide.
  • Shop With Confidence We respect your privacy; we always keep your information confidential.
  • What If I Need to Return This Item? Not a problem! If you are not happy with your purchase, we will gladly help you exchange or return your items, provided you follow the guidelines outlined in our Returns Policy.
Give Us a Call
(877) 634-0063
Whether you have technical questions for our ASE certified staff or you need help fulfilling an order, we're here to help you.
Email Us Live Chat

Customer Reviews

Write a Review No reviews yet. Would you like to be the first one?
Keep me posted
Sign up for Special Offers, News, & Promos from FCP.